Technik > Tech-Talk Amps
Bias Drift bei aufgedrehtem Gain
Racing:
No offense but i´m still sitting here confused.?
Were we talking negative bias voltage or bias as in anode loss? Because if anode loss that is supposed to jump all over the place as you play the amplifier.
Bias voltage is indeed presented to point g1 of the powertubes. So is the actual signal. This g1 is the tubes control grid,and as the AC voltage of the signal starts to work its way towards it bias/loss is supposed to shift all over. Otherwise the tube,and hence the amp,simply won´t work.
cca88:
--- Zitat von: Racing am 19.10.2015 11:29 ---No offense but i´m still sitting here confused.?
Were we talking negative bias voltage or bias as in anode loss? Because if anode loss that is supposed to jump all over the place as you play the amplifier.
Bias voltage is indeed presented to point g1 of the powertubes. So is the actual signal. This g1 is the tubes control grid,and as the AC voltage of the signal starts to work its way towards it bias/loss is supposed to shift all over. Otherwise the tube,and hence the amp,simply won´t work.
--- Ende Zitat ---
...maybe he is probing quiescent current - at idle (before pounding the amp) - at idle (after a period of playin at higher volumes)
Wie sieht es mit den Werten der Biaswiderstände aus? Wirklich 220K?
Grüße
Jochen
raffau:
hey joe,
den Amp werde ich erst nächste Woche an einem Oszi kontrollieren. Aber die Ernüchterung ist gross, denn mein Kollege hat mich auch zusammen geschissen und meint dass das gar nicht geht....Das Ding schwingt weiterhin! Ich werde mit ihm den Amp ausmessen und mich wieder melden.
Ich merke, das mein Wissen, sehr beschränkt ist!
Gehe mal weiterlesen....
vg raffa
@Jochen; Ja, gestern alle Bauteile gemessen, Lötstellen nachgelöttet, Kabel neu verlegt, usw...Wie ich schon sagt, ich muss den Amp mit einem Oszi anschauen...Mir fehlt das Wissen! Ich werde aber Unterricht erhalten! ;D
Showitevent:
--- Zitat von: cca88 am 19.10.2015 11:38 ---
Wie sieht es mit den Werten der Biaswiderstände aus? Wirklich 220K?
--- Ende Zitat ---
Auch ein berechtigter Vorschlag! Bitte auch Biaspoti berücksichtigen!
Viel Erfolg!
Racing:
Might be,but in that case we´re basically talking incorrect measuring.
As i understood it this was a issue as he cracked the gainpots of the preamp open,and if so it in fact is besides the point if he played the amp or not.
If it stays calm as far as anodeloss in idle with the pots closed and then goes rampant as a front end pot is cracked open beyond a given point,then we have an issue that stems from the preamp/PI. Not the actual powertubes and their bias setting.
It is also a matter of that actual negative bias voltage will to an extent follow presented signal.
Something you´re as aware of as I.
Navigation
[0] Themen-Index
[#] Nächste Seite
[*] Vorherige Sete
Zur normalen Ansicht wechseln