Technik > Tech-Talk Amps

Marshall 2061X Clone MOD to Komet 19

(1/4) > >>

Leadman:
Hello to everyone,

I have a 40 watt 2 x12ax7 + 4xel48 building based on a Marshall 2061x (solid stage rectifier and a DC coupled long tail phase inverter). I put in that desing a fixed bias circuit to run the amp cooler.
The amp sounds amazing and you can get a good decent level of headroom in the Bass channel (putting the tone an volume controls of the lead channel at three oclock without jumpering), itīs perform like a excellent clean pedal plataform. You can get a awesome crunch sound jumpering channels and turn the volume up, but you get a lot of volume for   normal stage gigging. I have used this amp about two year without problems.
Now, I am going into no drive pedals and control the overdrive with the guitar volume and tone pots. Watching a lot of web info I have discovered that Komet k19 (or k29) goes in that way. Studing the inside pics on the net from the komet k19 k29 looks like the power amp topology is very similar to marshall 2061x but put a two stage cascade preamp into the Phase Inverter but the component values are not shown in the pics.
Do Anybody have any idea of how to MOD the 2061x schematic into a Komet 19/29 style amp or the correct values or schematic for that amp?
There is a mod running in the net called "swank Motee" that cascade one channel into the other, but I donīt like the way is implemented with two tone controls.
Another suitable desing could Be a Budda TwinMaster, but it donīt have a master volume and Iīm afraid that push that amp into overdrive could be too loud with a 40watt watts power amp, and the plate voltage will be lower than my clone because I donīt use tube rectifier. Otherwise I am not sure about the correct schematic and values.

Thanks in advanced for your help.

Best Regard from Spain.

mike45:
Hi Leadman,

some years ago i build a Komet19 Clone for a friend. I have drawn a schematic from a gutsshot of this amp. Hope you can use it.

Mike

Leadman:
Thank you so much!

Best Regards.

Leadman:
Hello again, how do you get the correct components values? Iīm looking the picture and all the resistor are covered.

Best Regards!

Leadman:
I have built the amp. The dual bright switch was omited, not bright cap was used. The amp is very trebbly and gainy. I have put a higher value snubber cap and now it's a bit better.

Some more ideas?

Best regards.

Navigation

[0] Themen-Index

[#] Nächste Seite