Technik > Tech-Talk Amps

Problem with ABY-Switch DIY

<< < (2/2)

haebbe58:
Pin 3 is right, it must be grounded, pin 2 should not be used ... pin 2 is the  middle tap of the primary coil and should only be used, if the source is balanced ... whe do not use balancing in this case!

So please use Pin 3, if you use Pin 2, the impedances do not match!

regards
haebbe

theschramm:

--- Zitat von: abbitxuelo am 17.12.2008 09:01 ---Hi!
Sorry but i donīt speak german. I wish that anybody can help me.

I mounted this aby-box  http://www.tube-town.net/diy/tt-aby/tt-aby.html
But i don't sure how solder the Xicon TM018 Audi-Transformator.

The picture is my setup, this is correct or wrong?

I have mount in this way, and i have a lot of noise in the B channel and when i connect a&b at the same time.

Can somebody help me? Thank you very much

--- Ende Zitat ---

Navigation

[0] Themen-Index

[*] Vorherige Sete