Tube-Town Forum
Technik => Informativ und Nützlich => Thema gestartet von: kentuckytukker am 29.05.2020 13:30
-
Hi amp. builders,
To solder the parts on the 6,3mm input sockets for my amp. projects I always first mount these sockets on the outside of the chassis and then solder the resistors and required bridge wires. After completion I remove the whole set and relocate them to the inside of the chassis. For me it is proven to be the most simple way the create a neath way of wiring/soldering.
gr, René
-
And here a 3D schematic diagram for extra clarification. This is the way HiWatt wires the sockets in their amps. Courtesy of MH